73587

==== PAGE 1 ====

Foul Drainage Proposed Surface Water Drainage Existing Above Ground Foul Drainage Proposed Foul Drainage Existing Surface Water Drainage Proposed NOTES: THESE DRAWINGS ARE COPYRIGHT OF ARCHITECTURE IN MANN AND CANNOT BE REPRODUCED WITHOUT WRITTEN PERMISSION. CONTRACTORS ARE TO CHECK ALL DIMENSIONS BEFORE SETTING OUT OR MANUFACTURE OF ANY FITTED ITEMS. IT IS ESSENTIAL THAT ALL NEW WORKS TO BE SET OUT ON SITE AND ANY DISCREPANCIES TO BE NOTIFIED TO ARCHITECTURE IN MANN PRIOR TO COMMENCEMENT OF CONSTRUCTION WORKS. DO NOT SCALE THESE DRAWINGS AND REPORT ANY DISCREPANCIES TO ARCHITECTURE IN MANN. Driveway Ground Floor Plan Proposed 1:50 Bedroom 2 Kitchen Bedroom 3 En suite En suite WC Utility Pantry Client Job No. Scale Drawing Title Drawing Number Project The Design Studio, 76 Summerhill Road, Onchan, IM3 1NH Tel: 626464 MOB: 470956 [email protected] Date Comment Rev Revision History Revision Date Status 21021 Mr & Mrs Rimmer @A1 Proposed Ground Floor Plan 04 18 Manor Park, Onchan A August 2021 BREGS existing inner door and glazed screen to be removed and ceiling void over checked for insulation and if missing added to match remainder of existing roof stud partition to be added to create pantry existing surface water system existing foul water system Proposed Master Bedroom Proposed en-suite Proposed dressing room new window to be installed - see elevation for sizes Millboard composite decking on ????/ joists at 400mm centres supported by joist hangers built in to new wall/chemiaal anchored to existing wall Existing facing brickwork extended vertically to support decking joists, finished with coping stone and glass balustrade. 1100 New casement window to match existing 675 1200 New external oil fired boiler on concrete plinth - to specialist installation Velux suntube to be installed to provide natural light to dressing area Existing garage door to be removed and opening infilled with cavity blockwork and 2no windows with cills and rendered finish all to match existing Minimum 270mm Rockwool Loft Roll insulation on VCL to be installed within existing roof space to achieve U value of 0.16W/m2K Existing cavity blockwork to be dry lined with 75 x 50mm battens at 600mm centres. Walls to be insulated to achieve minimum 0.25 w/m2K utilising 50mm Kingspan Kooltherm K12 framing board fitted between studs lined internally with Kingspan Kooltherm K 118 Insulated plasterboard and skim. Garage floor to be overlaid with breather membrane prior to 197 x 47mm SC3 slab bearing frame with joists at 600mm centres being installed. Floor to be insulated with 100mm Kingspan Thermafloor T70 installed between joists prior to vapour control layer and 19mm chipboard being installed over all to achieve U value of 0.22w/m2K. Ensure 20mm perimeter insulation installed to prevent cold bridging Upper floor to comprise 147 x 47mm joists at 400mm centres supported off joist hangers one end 196 x 75mm floor bearer the other side. Floor to be insulated with 100mm Kingspan Thermafloor T70 installed between joists prior to vapour control layer and 19mm chipboard being installed over all to achieve U value of 0.22W/m2K. Ensure 20mm perimeter insulation installed to prevent cold bridging. Existing garage door to be removed and opening infilled with cavity blockwork with damcor dpc to new window reveals/ cavities broken through to ensure continuity. 2no windows to be installed with concrete cills bedded on dpc. Blockwork to be render finished with raised bands to match existing existing no-loadbearing walls to be removed stud partition to be added to create WC where en-suite Bathroom currently exists new 100mm diameter foul connection new external oil fired condensing boiler on 150mm concrete plinth Existing garage walls to be dry lined with 75 x 50mm battens at 600mm centres. Walls to be insulated to achieve minimum 0.25 w/m2K utilising 50mm Kingspan Kooltherm K12 framing board fitted between studs lined internally with Kingspan Kooltherm K 118 Insulated plasterboard and skim. SD HD Heat Detector Smoke Detector Fire legend half hour fire resisting, self closing door SD HD SD Drainage legend South West Elevation Proposed 1:100 South East Elevation Proposed 1:100 North West Elevation of Garage area Proposed 1:100 Section through Garage Proposed 1:100 Section through proposed decking 1:100 Existing garage door to be removed and opening infilled with cavity blockwork and 2no windows to be installed with concrete cills bedded on dpc. Blockwork to be render finished with raised bands to match existing horizontal dpc at min 150mm above external ground level Millboard or other composite decking on 147 x 47 SC3 joists at 400mm centres supported by joist hangers built into new wall/chemically anchored to existing wall Existing facing brickwork wall extended vertically to support decking joists and min 1100mm high glass/composite balustrade installed Existing steps to be removed and new extended set of stairs formed to suit new deck level FD FD FD A 19/04/22 Project changed to garage conversions and internal alterations with raised deck over existing patio. Existing facing brickwork extended vertically to support decking joists, finished with coping stone and glass/composite balustrade. 1500 2500 3665 2600 2 x 600mm pocket doors 1 x 850mm pocket door 1 x 800mm pocket door 5800 FD